NOTE: This kit works on water-cooled engines only.
This cab heater system uses your engine's hot water to heat the cab of your UTV or Side By Side just like your car. Full cab enclosures go a long way towards keeping you from freezing in the winter by blocking the wind but that only goes so far. Just imagine how comfortable you will be when you install one of the Side By Side hot water cab heaters in conjunction with your full cab enclosure....ya, that's would be pretty awesome wouldn't it?
This heater unit is sized right and has a mounting bracket that rotates 180 degrees, giving you the flexibility to mount this thing practically anywhere (floor, firewall, or under the dash). It puts out an estimated 4000 BTU of heat and draws 0-2 amps of electrical power. The integrated variable speed switch allows the operator to set the comfort level. The mounting kit comes with all the fittings and necessities you will need to get the job done. It even includes a hole saw to cut the perfect size hole to get your hoses through the firewall. The diverter valve ensures that the engine's hot water will flow through the heater providing plenty of heat. Get your cab heater today and stay warm all winter long.
Heater Features:
- Maximum 6,000 BTUs per hour - fan output 200 CFM
- Rigid mounting bracket with 180-degree bracket rotation
- Locking clamp support
- Integrated variable-speed switch
- Constructed of high strength nylon 6/6 housing
- Box includes heater, mounting bracket, universal attachment screws, and instructions
Heater Specifications:
- BTU max: 6,000/hr
- Fan output: 0 to 200cfm
- 12-v DC amp draw: < 2 amps
- Size: 9.5" w x 5.5" d x 5.5" h
- Weight: 3.5 lbs
Installation Kit Features:
- Plumbs directly into 22mm, 3/4" or 1" radiator hoses
- Gives control of hot water throughput
- Protects against engine overheating
- Maximizes heat output
- Kit includes:
- Aqua-Hot diverter manifold valve
- Barbed fitting assortment: 1/2" NPT x 3/4"; 3/4" NPT x 1"; 3/4" NPT x 22mm
- Backing plate
- Drill bit - #9
- Hole saw - 1.5" with a pilot bit
- Grommet - 1" bore x 1/4" groove
- Heater hose - 10 feet x 3/4"
- Constant tension clamps - #290
- Worm drive clamps
- 20 gauge red wire - 10 feet
- Fuse holder - in-line blade type
- Fuse - 5 amp spade type
- Connectors - butt-end 18-22 gauge and tap-splice 18-22 gauge
- Teflon tape roll