Polaris Ranger 1000/XP 1000/XD 1500 Glacier Adapter 2.0 Swift-Latch by KFI

KFI 2.0 Swift-Latch^™ (Glacier Adapters) are designed to be permanently attached to the Pro 2.0 UTV Push Tubes (106300) and keeps the plow mount off of your machine during spring, summer, and fall. Designed for the following “stock” Full-Size Polaris Rangers with the Glacier Bumper installed. Mid-Size Polaris Machines (unless modified) are too low to use the current Swift-Latch^™ (Glacier Adapters) properly. Ensure the correct KFI Swift-Latch^™ (Glacier Adapter) is ordered for your push tubes. The 106345 and 106630 are ONLY compatible with Pro 2.0 Push Tubes (106300). If you have the Discontinued Round Style Push Tubes, you would need to look at our other KFI Swift-Latch^™ (Glacier Adapter) option 105975.

The Polaris glacier bar height is critical. If your machine is listed below, but you have (or are going to install) tracks, larger tires, or a lift kit, we recommend measuring the glacier bar when your machine is set up the way you like, then choose the appropriate height Swift-Latch^™ (Glacier Adapter). An alternate mount may be available for your machine that will be compatible with our push tube leveling kits.

Improper geometry can lead to a bad blade angle and/or force being applied incorrectly. The optimal height of the 106345 Std. The Polaris Glacier Bar mounting location should be 14” from the ground. The optimal height of the 106630 Tall Swift-Latch^™ (Glacier Adapter) mounting location should be 17” from the ground. See images below for reference.

If your machine isn’t listed in the table, but you have the Pro 2.0 Push Tubes and a glacier bumper that matches the measurements shown in the photos above, you can use the corresponding Swift-Latch^™ (Glacier Adapter) based on your height.